Search results for query: *

  1. Mike Caldwell

    Soundcraft UI12 wifi connection issues

    When this topic thread first started and even more so now 2.4g WIFI is very crowded. Use 5g and get at least a WIFI scanner APP to look at what is in use in the area your working in. I use WIFI MAN, it' an Android APP, not sure if there are any WIFI scanner APP for iOS. See what channels are in...
  2. Mike Caldwell

    Worthwhile first speaker repair project? (Sony SS-4200)

    You could use the cabinets as a starting point to built up a new speaker with some re work of the front baffle.
  3. Mike Caldwell

    classic rock reproduction

    At the very least your going to need a four way crossover and as Art mentioned some proper adjustment to get that speaker stack to kind of all work together. A dust rag wouldn't hurt either!! You may be a classic rock tribute band but that does not mean you need to use a "classic rock" PA...
  4. Mike Caldwell

    Signal Passing Through Audio Interface When Knobs Are At Zero

    Maybe the input gain controls do not by design fully attenuate the input. 0db gain will still pass a signal and is not off so to speak.
  5. Mike Caldwell

    Impossible sound installation? DIY project needs expert assistance

    And it has a simple yet effective software control interface. Another DSP that sells for cheap on Ebay are the BiAmp Nexia units, not as easy to program but they are fully customizable. A couple hundred or less will get you a DSP that new was around $2000 more or less depending on the version.
  6. Mike Caldwell

    Microphone impedance

    Keep in mind the Shure mic headphone combo uses a dynamic mic so it does not need any bias/phantom power applied.
  7. Mike Caldwell

    Microphone impedance

    You must have already made up a break out cable or re terminated the Shure cable with other connectors as the Rode units only have 3.5mm inputs. Maybe post a picture or two.
  8. Mike Caldwell

    Microphone impedance

    What are you connecting them to. The connector pin out wiring may need to be changed,
  9. Mike Caldwell

    Impossible sound installation? DIY project needs expert assistance

    What's going to be used for, studio, home theater, live sound ? What is you budget?
  10. Mike Caldwell

    Door?

    Yes! You went to a lot of work to a keep an acoustic drum kit "in the mix" when 97% of the people in congregation would not notice the difference between an acoustic kit and an E Drum kit sound. Think if you need to re arrange the stage for a special event.
  11. Mike Caldwell

    Soundcraft UI12 wifi connection issues

    For anything close to a reliable connection with those you need to set up an external WIFI router. Anything operating in the 2.4g WIFI band is asking for issues in a crowed room full of cell phones.
  12. Mike Caldwell

    Dim tweeter

    That one is toast and so would have been the diaphragm had it been in there.
  13. Mike Caldwell

    Dim tweeter

    If the pole piece and or the top plate has shifted that is whole other level of repair, if repairable. With the gap visibility uneven that driver is not going to sound like it should, if the pole piece slips anymore with the diaphragm installed it could ruin the good diaphragm. Sounds like that...
  14. Mike Caldwell

    Mic output from TRRS connector of gaming headset

    In my quick research that transmitter input is just a tip sleeve jack, going by the picture of the mic that plugs into it, You'll need to take the TRRS split and on the transmitter side get or make an adapter that the ring closest to the body of the TRRS plug and connect that to the tip and the...
  15. Mike Caldwell

    X32 Rack Matrix Phasing Issues

    Or somewhere a miss wired XLR cable.
  16. Mike Caldwell

    X32 Rack Matrix Phasing Issues

    Do you have those same source routed to the matrix using a second path so to speak, like through a group or a mix. Are the inputs double patched main left right and through an audio group also patched to the main left right.
  17. Mike Caldwell

    Wireless IEM not getting one channel

    For the sake of testing plug the click into a channel that is sending to the IEM and see what happens. What channels are you using for the click and tracks? Are they assigned to the mix that you are using for the IEM?
  18. Mike Caldwell

    Crackling/Clipping issues on Monitors

    Ok not trying to be harsh but just stating the facts.... Your speakers are not the greatist and on top of that expecting an 8 or 10 monitor to attempt to do what it sounds like your expectations are is going to give your the results your getting. High passing the monitor mix outputs upwards to...
  19. Mike Caldwell

    new wireless mics

    Yep, don't know why I didn't think of looking at your profile!!! From a quick check it looks like you are still OK to use 600mhz bandwidth wireless mics, double check though locally! That being the case with a little Ebay ect. shopping you should be able to find people selling off their old AT...
  20. Mike Caldwell

    new wireless mics

    The mics "breaking down" may just be interference causing them to drop out since they are operating in the 600mhz bandwidth that is now 90% occupied with cell phone transmission. Where are you located