Behringer EP2500 feed-through/daisy chaining. Possible?

Carl Klinkenborg

Active member
Oct 25, 2018
158
25
28
62
Bideford, Devon. UK
Hi All, apologies if this is general knowledge, but I'm damned if I can find it, and Behringer technical support don't know either! I wish to use three EP2500 amps in bridged mono driven by one XLR output. Please don't laugh too hard - I've been using these amps successfully for twenty years!

Can a single crossover output feed the first amp and out to the second one and thence to the third?

The parallel mode and using the TRS 1/4" jacks come to mind, however the manual states on one page that the parallel switches must be 'off' in bridged mode, yet on another states that if they are 'on' then the signal feeds through. I'm not in a position to physically test this with my amps at present and was posting to see what other folks know or do - I am trying to avoid a distribution amp! Cheers, Carl.