Hello i am ben
Long time reader
post very rare.
here is the rub.
my boss purchased 5 mac 250 + lights from an auction.
i have been tasked with repairs cleaning oiling and selling.
Over the next several months i will be posting on this thred my problems,
in the hope that one of you fine gentlemen and women would be kind enough to help me on my way.
If any one has a service manual i would like to get my hands on that. the manual that martin has online is good but sparse.
Also it would be nice to know were the best place for parts would be, i am located in the USA.
now for my first problem the light i am working on first has a PAER (pan time out Error)
I have cleaned the optical sensor, and made sure that the connector is attached.
The bump stop/switch on the light does not engage properly.
could this cause my troubles.
thank you for all your help.
Long time reader
post very rare.
here is the rub.
my boss purchased 5 mac 250 + lights from an auction.
i have been tasked with repairs cleaning oiling and selling.
Over the next several months i will be posting on this thred my problems,
in the hope that one of you fine gentlemen and women would be kind enough to help me on my way.
If any one has a service manual i would like to get my hands on that. the manual that martin has online is good but sparse.
Also it would be nice to know were the best place for parts would be, i am located in the USA.
now for my first problem the light i am working on first has a PAER (pan time out Error)
I have cleaned the optical sensor, and made sure that the connector is attached.
The bump stop/switch on the light does not engage properly.
could this cause my troubles.
thank you for all your help.
Last edited: