Reply to thread

Message

<blockquote data-quote="Jason Kelly" data-source="post: 60307" data-attributes="member: 278">Re: Midas Pro2 Monitor routingHi Fredrik,The PRO3/6/9 doesn&#039;t have a mode to achieve what you&#039;d like to do, but because the monitor section of those consoles is basically analogue its possibly a little easier to set up. The PRO2 is fully digital within the monitor section, so it needs to be done in a slightly different way. But the sequence below will allow you to do the following:Outputs set to MonitorB will only go to B onlyInputs and Outputs set to MonitorA will go to both A &amp; B outputsSolo Clear will only clear channels solo&#039;ed on MonitorAMonitorB will need to be cleared manually.Setup:1) In Monitor Preferences switch the console to Broadcast mode2) Select &#039;EXT&#039; on MonitorA3) Turn up the PFL &amp; AFL levels ro 0dB4) Switch all the IEM outputs back to solo A5) Patch MonitorB outputs L+R to EXT Input Source L+RHope this gets you where you need to be.</blockquote>

[QUOTE="Jason Kelly, post: 60307, member: 278"] Re: Midas Pro2 Monitor routing Hi Fredrik, The PRO3/6/9 doesn't have a mode to achieve what you'd like to do, but because the monitor section of those consoles is basically analogue its possibly a little easier to set up. The PRO2 is fully digital within the monitor section, so it needs to be done in a slightly different way. But the sequence below will allow you to do the following: Outputs set to MonitorB will only go to B only Inputs and Outputs set to MonitorA will go to both A & B outputs Solo Clear will only clear channels solo'ed on MonitorA MonitorB will need to be cleared manually. Setup: 1) In Monitor Preferences switch the console to Broadcast mode 2) Select 'EXT' on MonitorA 3) Turn up the PFL & AFL levels ro 0dB 4) Switch all the IEM outputs back to solo A 5) Patch MonitorB outputs L+R to EXT Input Source L+R Hope this gets you where you need to be. [/QUOTE]

Verification