Reply to thread

Message

<blockquote data-quote="Antoon van den Oetelaar" data-source="post: 148686" data-attributes="member: 3005">Re: X32 and outboard rack....anyone use oneSorry someone correct me, but to be honest I think you&#039;re wrong.In that picture, on that tab of AES50-b you set the signals going to the b connector, so to a X32P as indicated above, with the green (led) dot in front.So AES50 B outputs 1-8 gets it&#039;s source from AES50 A1-8, that means that these signals pass from the A input directly to the B output, with a S16 connected this means channel 1-8 of the S16 is passed through to the second X32.Same for Outputs 9-16Outputs 17-24 and 25-32 are set to A17-24 and A25-32, in case of 2 times S16 these are channel 1-16 of the last S16 in the row. (But from that picture it&#039;s not for sure that a second S16 is connected)Outputs 33-40 are set to Local 1-8, Outputs 41-48 are set to Local 9-16.I&#039;m quite sure that these are no local inputs but the local outputs, as set on the out1-16 tab.I could check it, but my X32&#039;s are stored...xlr out has been added in newer firmware versions, and they can be routed from local out1-16, (As was by default the case) but also from other sources, so the XLR outputs on the console are not binded to that console but can have it&#039;s source also from the AES50. So you can output a signal send from the monitor console on the FOH position, without needing it to route through the inputs of the board. I hope this does make sense.</blockquote>

[QUOTE="Antoon van den Oetelaar, post: 148686, member: 3005"] Re: X32 and outboard rack....anyone use one Sorry someone correct me, but to be honest I think you're wrong. In that picture, on that tab of AES50-b you set the signals going to the b connector, so to a X32P as indicated above, with the green (led) dot in front. So AES50 B outputs 1-8 gets it's source from AES50 A1-8, that means that these signals pass from the A input directly to the B output, with a S16 connected this means channel 1-8 of the S16 is passed through to the second X32. Same for Outputs 9-16 Outputs 17-24 and 25-32 are set to A17-24 and A25-32, in case of 2 times S16 these are channel 1-16 of the last S16 in the row. (But from that picture it's not for sure that a second S16 is connected) Outputs 33-40 are set to Local 1-8, Outputs 41-48 are set to Local 9-16. I'm quite sure that these are no local inputs but the [B]local outputs[/B], as set on the out1-16 tab. I could check it, but my X32's are stored... xlr out has been added in newer firmware versions, and they can be routed from local out1-16, (As was by default the case) but also from other sources, so the XLR outputs on the console are not binded to that console but can have it's source also from the AES50. So you can output a signal send from the monitor console on the FOH position, without needing it to route through the inputs of the board. I hope this does make sense. [/QUOTE]

Verification