Reply to thread

Message

<blockquote data-quote="Per SÃ¸vik" data-source="post: 100524" data-attributes="member: 1285">Re: Master/Slave X32 with X32 CompactLet&#039;s see. Is 7-8 configured as SubGroup (recommended) or PostFader on your sends? If so, are you channel faders up?Are the sends unmuted? There are some quirks that you might come across at this point: Assuming you are using SubGroup, and you select mixbus 7 or 8 and then sends on fader, and proceed to pull up the faders to get signal to the subgroup. You&#039;d think that you would get a signal, wouldn&#039;t you? Well, you can move the faders, but in subgroupmode they are deactivated and perform no function.So, if you are in subgroup mode for the send to 7-8, then it is the actual channel fader that governs the level. If the channel faders are up, channel and sends are unmuted, then let&#039;s move on to DCA. Any DCA assigned to the channels or mixbuses in question, if so then unassign or make sure the DCA faders are pulled up to zero.By now you should have signal on the mixbus.If at any point you give up or need advice about something, save the scene to a usb stick and post it for us to have a look</blockquote>

[QUOTE="Per SÃ¸vik, post: 100524, member: 1285"] Re: Master/Slave X32 with X32 Compact Let's see. Is 7-8 configured as SubGroup (recommended) or PostFader on your sends? If so, are you channel faders up? Are the sends unmuted? There are some quirks that you might come across at this point: Assuming you are using SubGroup, and you select mixbus 7 or 8 and then sends on fader, and proceed to pull up the faders to get signal to the subgroup. You'd think that you would get a signal, wouldn't you? Well, you can move the faders, but in subgroupmode they are deactivated and perform no function. So, if you are in subgroup mode for the send to 7-8, then it is the actual channel fader that governs the level. If the channel faders are up, channel and sends are unmuted, then let's move on to DCA. Any DCA assigned to the channels or mixbuses in question, if so then unassign or make sure the DCA faders are pulled up to zero. By now you should have signal on the mixbus. If at any point you give up or need advice about something, save the scene to a usb stick and post it for us to have a look [/QUOTE]

Verification