Reply to thread

Message

<blockquote data-quote="John Koepke" data-source="post: 123893" data-attributes="member: 7691">Re: X32 DiscussionI have been noticing a small issue (Possibly not small at all), and would like some ideas of what could be going on..&nbsp; I have an X32 and an S16.&nbsp; The X32 is running Firmware 2.04, but this has been happening when i was running 1.15.&nbsp; If I use outputs 15 &amp; 16 for Main LR outputs to a pair of JBL PRX615&#039;s, the sound is great..&nbsp; But if I connect my S16 to AES port A, set it up as 1-8, and route output 9-16 to AES550-A 1-8 the volume is almost 1/2 of what the console outputs.As a test, I plugged both speakers into outs 15 and 16 on the board, and the volume of both are equal.&nbsp; If i unplug one of the speakers and plug it into OUT 7 or 8, the volume is 1/2 of the speaker plugged into the X32.&nbsp; I have Green Sync lights on both the S16 and the X32.&nbsp; I have tried both AES550 A and B ports on the X32, both exhibit the same behavior.&nbsp;&nbsp; Before you ask, yes I have tried different XLR cables.I also plugged a SM58 into port 1 on the S16, routed it to Channel 27 on the X32.&nbsp; To get around -9db on the meter, I need to crank the gain to +47.0.&nbsp; If I plug directly into port 27 on the X32 and change the route, and crank it to +47 on the gain, I clip the channel reading the same paragraph (A website I brought up and read from.)..I think I need to send it in for repair, but wanted to get other advice before I did so.&nbsp; Thanks for any help.</blockquote>

[QUOTE="John Koepke, post: 123893, member: 7691"] Re: X32 Discussion I have been noticing a small issue (Possibly not small at all), and would like some ideas of what could be going on.. I have an X32 and an S16. The X32 is running Firmware 2.04, but this has been happening when i was running 1.15. If I use outputs 15 & 16 for Main LR outputs to a pair of JBL PRX615's, the sound is great.. But if I connect my S16 to AES port A, set it up as 1-8, and route output 9-16 to AES550-A 1-8 the volume is almost 1/2 of what the console outputs. As a test, I plugged both speakers into outs 15 and 16 on the board, and the volume of both are equal. If i unplug one of the speakers and plug it into OUT 7 or 8, the volume is 1/2 of the speaker plugged into the X32. I have Green Sync lights on both the S16 and the X32. I have tried both AES550 A and B ports on the X32, both exhibit the same behavior. Before you ask, yes I have tried different XLR cables. I also plugged a SM58 into port 1 on the S16, routed it to Channel 27 on the X32. To get around -9db on the meter, I need to crank the gain to +47.0. If I plug directly into port 27 on the X32 and change the route, and crank it to +47 on the gain, I clip the channel reading the same paragraph (A website I brought up and read from.).. I think I need to send it in for repair, but wanted to get other advice before I did so. Thanks for any help. [/QUOTE]

Verification