Hey ya guys, I managed to get myself a Dbx Driverack PA for a cheap price, I need a bit of help with setting the limiters on it is possible. Do you think you could help me? I've got two Peavey UL215H mid/highs which are rated at 1,000 watts continuous average power and 2,000 watts program and they're 4 ohms. They're being powered by Yamaha P7000S amplifier, with one cab per channel in stereo. The Yamaha P7000S specs are here :
http://www.yamahaproaudio.com/global/en/products/poweramps/ps_series/specifications.jsp
Below are the limiter threshold settings i've got for the Driverack PA on the high frequency outputs of the unit based on using the limiter threshold calculator, can you tell me if the threshold value looks accurate?
http://www.poulpetersen.dk/Appn/gblimthc.html
And for the low frequency outputs i've got two JBL SRX728S subs which are rated at 1,600 watts continuous average power and 3,200 watts program, they're 4 ohms. Powering them i've got one JBL MPA750 bridged per sub. Here's the specs for the JBL MPA750 :
http://www.jblproservice.com/pdf/MPA Series/MPA750.pdf
Below are the settings for the threshold i've got using the same threshold calculator :
http://www.poulpetersen.dk/Appn/gblimthc.html
Does the threshold setting look correct on this one too? I've selected 2 ohms for nominal load of the amplifier because from what I know bridging an amplifier into 4 ohms is using the amplifier as dual 2 ohms right? Or should I select 4 ohms for nominal impedance of the amplifier because i'm bridging at 4 ohms?
Can you guys check these threshold settings are correct and if possible, give me your idea of what you think would be a good setting for the 'Over Easy' setting? Thanks guys, I apreciate your help.
http://www.yamahaproaudio.com/global/en/products/poweramps/ps_series/specifications.jsp
Below are the limiter threshold settings i've got for the Driverack PA on the high frequency outputs of the unit based on using the limiter threshold calculator, can you tell me if the threshold value looks accurate?
http://www.poulpetersen.dk/Appn/gblimthc.html
And for the low frequency outputs i've got two JBL SRX728S subs which are rated at 1,600 watts continuous average power and 3,200 watts program, they're 4 ohms. Powering them i've got one JBL MPA750 bridged per sub. Here's the specs for the JBL MPA750 :
http://www.jblproservice.com/pdf/MPA Series/MPA750.pdf
Below are the settings for the threshold i've got using the same threshold calculator :
http://www.poulpetersen.dk/Appn/gblimthc.html
Does the threshold setting look correct on this one too? I've selected 2 ohms for nominal load of the amplifier because from what I know bridging an amplifier into 4 ohms is using the amplifier as dual 2 ohms right? Or should I select 4 ohms for nominal impedance of the amplifier because i'm bridging at 4 ohms?
Can you guys check these threshold settings are correct and if possible, give me your idea of what you think would be a good setting for the 'Over Easy' setting? Thanks guys, I apreciate your help.
Last edited: