Log in
Register
Home
Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
News
Members
Current visitors
New profile posts
Search profile posts
Features
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Menu
Install the app
Install
Reply to thread
Home
Forums
Low Earth Orbit
DIY Audio
60 Degree DIY Mid Hi - AKA PM60
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Don J Davis" data-source="post: 139340" data-attributes="member: 248"><p>Re: 60 Degree DIY Mid Hi</p><p></p><p></p><p></p><p>Hi Mark,</p><p>You are right on with these observations. In the Sketchup version I increased the overall box width to 396mm to yield a 362mm inside width. According to the spec sheet, the cut out for the XT1464 is 362 wide.</p><p>Then as you said the horn flange would need to be recessed into the edges of the sides. I am expecting a XT1464 to be delivered this week. Once I have my hands on it I'll see if that width can be reduced.</p><p>I haven't found a source for the HF950 in the US yet.</p><p></p><p>To have a one piece grill the box will need to be wider to allow the horn to fit between the sides.</p><p></p><p>My goal is to stay as true as possible to Peter's design parameters. Of course everyone can vary the design to fit their own needs.</p><p></p><p>I hope to start my build sometime this week. </p><p></p><p>Don</p></blockquote><p></p>
[QUOTE="Don J Davis, post: 139340, member: 248"] Re: 60 Degree DIY Mid Hi Hi Mark, You are right on with these observations. In the Sketchup version I increased the overall box width to 396mm to yield a 362mm inside width. According to the spec sheet, the cut out for the XT1464 is 362 wide. Then as you said the horn flange would need to be recessed into the edges of the sides. I am expecting a XT1464 to be delivered this week. Once I have my hands on it I'll see if that width can be reduced. I haven't found a source for the HF950 in the US yet. To have a one piece grill the box will need to be wider to allow the horn to fit between the sides. My goal is to stay as true as possible to Peter's design parameters. Of course everyone can vary the design to fit their own needs. I hope to start my build sometime this week. Don [/QUOTE]
Insert quotes…
Verification
Post reply
Home
Forums
Low Earth Orbit
DIY Audio
60 Degree DIY Mid Hi - AKA PM60
Top
Bottom
Sign-up
or
log in
to join the discussion today!