Normal
Re: 60 Degree DIY Mid HiHi Max,I don’t have an issue with you releasing a CAD / CNC file. I’m actually very grateful for the all the helpI have had so far, and that some people have actually been brave enough to build my design.8O~8-O~:shock:~~:smile:A couple of suggestions – If you are going down the CNC path you should make the two braces that go from the inner section to top and bottom of the box wider where they connect the top and bottom of the box. Then route some hole(s) in the braces to reduce the weight. I don’t think you need a side access panel. The two twelve inch drives fit through the horn cut-out and it’s just as easy to remove the horn and do maintenance as it is to remove a side panel. It’s also lighter and stronger without a cut-out.
Re: 60 Degree DIY Mid Hi
Hi Max,
I don’t have an issue with you releasing a CAD / CNC file. I’m actually very grateful for the all the help
I have had so far, and that some people have actually been brave enough to build my design.8O~8-O~:shock:~~:smile:
A couple of suggestions –
If you are going down the CNC path you should make the two braces that go from the inner section to top and bottom of the box wider where they connect the top and bottom of the box. Then route some hole(s) in the braces to reduce the weight.
I don’t think you need a side access panel. The two twelve inch drives fit through the horn cut-out and it’s just as easy to remove the horn and do maintenance as it is to remove a side panel. It’s also lighter and stronger without a cut-out.
