Re: 60 Degree DIY Mid Hi
Okay so six hours of fighting with ye olde ShopBot later and I'm here to tell you - find a panel saw instead. It's far easier, it's faster, and - most importantly - cheaper. If you don't have access to one, change that. Just remember to cut on your lines, not the integrated rules.
That said, the handle cutouts, horn baffle, the occasional strange brace and especially the 12" baffle are all good candidates for CNC routing.
I won't say much regarding my experience this evening, but I will say that 14000 and 70 is not the best solution for 18mm ply of any kind and, as it turns out, the spoil board on the machine I was using is not flat. Goodnight (at 7:20 in the morning).
