Reply to thread

Message

<blockquote data-quote="Mark Wilkinson" data-source="post: 141010" data-attributes="member: 8989">Re: 60 Degree&nbsp; DIY Mid HiThanks for those two explaining posts.&nbsp; They are slowly beginning to make some sense....especially as I read back over previous posts where you describe modeling and design decisions...In thinking about building some more 60 DIY boxes.... I&#039;d love to get the XT1464 all the way inside the walls.&nbsp; Does that necessary extra width matter as far the way the slot under the 12&quot; expands into the beginning of the MF horn? I&#039;m thinking not much really,..... partly because I see it&#039;s ok to lop the corners off the box, the way you&#039;re doing. &nbsp;I mean, doesn&#039;t the corner &quot;lop off&quot; make for a slight restriction?....which evidently doesn&#039;t matter...? So maybe things about the MF horn aren&#039;t so critical....Maybe the right question is what dimensions or flare particulars are critical?And I know you left your 60 degrees the full depth you had available without cutting any off.&nbsp;&nbsp; That would appear to give some help to directivity per your above post.Did you keep the depth for that? , or to keep your box looking as good as it does !</blockquote>

[QUOTE="Mark Wilkinson, post: 141010, member: 8989"] Re: 60 Degree DIY Mid Hi Thanks for those two explaining posts. They are slowly beginning to make some sense....especially as I read back over previous posts where you describe modeling and design decisions... In thinking about building some more 60 DIY boxes.... I'd love to get the XT1464 all the way inside the walls. Does that necessary extra width matter as far the way the slot under the 12" expands into the beginning of the MF horn? I'm thinking not much really,..... partly because I see it's ok to lop the corners off the box, the way you're doing. I mean, doesn't the corner "lop off" make for a slight restriction?....which evidently doesn't matter...? So maybe things about the MF horn aren't so critical.... Maybe the right question is what dimensions or flare particulars [I]are[/I] critical? And I know you left your 60 degrees the full depth you had available without cutting any off. That would appear to give some help to directivity per your above post. Did you keep the depth for that? , or to keep your box looking as good as it does ! [/QUOTE]

Verification