Reply to thread

Message

<blockquote data-quote="Peter Morris" data-source="post: 148854" data-attributes="member: 652">Re: 60 Degree&nbsp; DIY Mid HiHow much difference does the rubber make … Hmmm next question.To be serious, I’m not sure, I was chasing down some of issues and I changed a couple of things ... everything got better, adding the rubber was one of the things I did.From past experience hard plastic horns often have resonant problems. I have measured the resonance with accelerometers, this time I just stuck some cheap 3mm rubber on the horn … it was just much easier to do that than try and measure it … I think the impulse response looked slightly better.I suspect you many not notice any change by doing this, but if you find and correct 10 little insignificant problems, you will hear the difference.</blockquote>

[QUOTE="Peter Morris, post: 148854, member: 652"] Re: 60 Degree DIY Mid Hi [FONT=Calibri][SIZE=3][COLOR=#000000]How much difference does the rubber make … Hmmm next question.[/COLOR][/SIZE][/FONT] [FONT=Calibri][SIZE=3][COLOR=#000000]To be serious, I’m not sure, I was chasing down some of issues and I changed a couple of things ... everything got better, adding the rubber was one of the things I did.[/COLOR][/SIZE][/FONT] [FONT=Calibri][SIZE=3][COLOR=#000000]From past experience hard plastic horns often have resonant problems. I have measured the resonance with accelerometers, this time I just stuck some cheap 3mm rubber on the horn … it was just much easier to do that than try and measure it … I think the impulse response looked slightly better.[/COLOR][/SIZE][/FONT] [SIZE=3][COLOR=#000000][FONT=Calibri]I suspect you many not notice any change by doing this, but if you find and correct 10 little insignificant problems, you will hear the difference.[/FONT][/COLOR][/SIZE] [/QUOTE]

Verification