Reply to thread

Message

<blockquote data-quote="Andy Turner" data-source="post: 203164" data-attributes="member: 10677">Thanks a lot Peter van Gils. Your help is very much appreciated.As I wanted to check where I could share angle cuts I found that my simple school angle-thingie wouldn&#039;t give me more than 40 degrees between part A and the horn baffle, and not 50 as the drawing says. Maybe I need more practice :0) More importantly, It would be very very helpful to have some more measurements on the plan as guideline to newbies as me :0).I wouldn&#039;t have started building without Don&#039;s plan so thank you Don, but I think it would be a great help to know the inside measurement from part D to inside of horn baffle and/ or some x y&nbsp; measurements for the panel placement (A B C, 12&quot; baffle and horn baffle).&nbsp; Would it be possible to extract those measurements directly from the program that was used to make the plan? Please let me know if you think I can help with this.</blockquote>

[QUOTE="Andy Turner, post: 203164, member: 10677"] Thanks a lot Peter van Gils. Your help is very much appreciated. As I wanted to check where I could share angle cuts I found that my simple school angle-thingie wouldn't give me more than 40 degrees between part A and the horn baffle, and not 50 as the drawing says. Maybe I need more practice :0) More importantly, It would be very very helpful to have some more measurements on the plan as guideline to newbies as me :0). I wouldn't have started building without Don's plan so thank you Don, but I think it would be a great help to know the inside measurement from part D to inside of horn baffle and/ or some x y measurements for the panel placement (A B C, 12" baffle and horn baffle). Would it be possible to extract those measurements directly from the program that was used to make the plan? Please let me know if you think I can help with this. [/QUOTE]

Verification