Reply to thread

Message

No, actually the design I followed was one of the earlier designs that was posted. From what I am seeing in the newest design posted above, it differs considerably in some areas than the model I went off of - namely in the legth of B/A due to my 60 degree horn baffle being less offset from the front of the box. That said, I could concievably recreate any adjustment to dimensions using my model to ensure that there are no issues with the dimensions presented (the software math is perfect as opposed to normal CAD drawings which can have slight errors that may cause issues further down the line if going the CNC route like I did).

[QUOTE="Max Warasila, post: 203259, member: 3845"] No, actually the design I followed was one of the earlier designs that was posted. From what I am seeing in the newest design posted above, it differs considerably in some areas than the model I went off of - namely in the legth of B/A due to my 60 degree horn baffle being less offset from the front of the box. That said, I could concievably recreate any adjustment to dimensions using my model to ensure that there are no issues with the dimensions presented (the software math is perfect as opposed to normal CAD drawings which can have slight errors that may cause issues further down the line if going the CNC route like I did). [/QUOTE]

Verification