Don, Max.
Thank you very much for sharing. I really appreciate your help a lot.
My main concern is of cause clearance for the CD. Internal volume and horn length I think is not so sensitive.
It seems that the new(60 degree) plans has less distance from Horn baffle to Part D, than Max's version?
If I am reading the plans correctly that is :0)
Max version internal depth: 370.
Don's version internal depth: 345.42. - Would this still be ok for the 90 degree version?
Good idea to put the print directly on the side panel, and just follow the bends/curves, but I was hoping to have enough measurements - x/y for each panel, to draw it instead of printing and attaching. Most important is still the total internal depth though.
Thanks again to both of you :0)
