Log in
Register
Home
Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
News
Members
Current visitors
New profile posts
Search profile posts
Features
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Menu
Install the app
Install
Reply to thread
Home
Forums
Low Earth Orbit
DIY Audio
60 Degree DIY Mid Hi - AKA PM60
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Don J Davis" data-source="post: 212763" data-attributes="member: 248"><p>I can't speak for Max's drawing but my 60 deg and 90 boxes are the same size the difference being the cut out for the horn. I chose to cut off the back corners for the reasons Peter did, looks. That small of a cut off doesn't make a big difference for arraying them. You can't make the cut off any bigger or you will hit the 12" drivers. When I built the 60's I actually built the cut off corners into the box as my drawings showed I believe. When I built the 90s I built the boxes square and used a saw to cut off the corners then fitted a panel over the opening. Again Peter's method which was way easier than my first builds.</p><p>My boxes where cut and built by hand. My drawings were never set up for CNC like Max's. His drawings took the design to the next level.</p><p>Hope this helps.</p><p>Don</p></blockquote><p></p>
[QUOTE="Don J Davis, post: 212763, member: 248"] I can't speak for Max's drawing but my 60 deg and 90 boxes are the same size the difference being the cut out for the horn. I chose to cut off the back corners for the reasons Peter did, looks. That small of a cut off doesn't make a big difference for arraying them. You can't make the cut off any bigger or you will hit the 12" drivers. When I built the 60's I actually built the cut off corners into the box as my drawings showed I believe. When I built the 90s I built the boxes square and used a saw to cut off the corners then fitted a panel over the opening. Again Peter's method which was way easier than my first builds. My boxes where cut and built by hand. My drawings were never set up for CNC like Max's. His drawings took the design to the next level. Hope this helps. Don [/QUOTE]
Insert quotes…
Verification
Post reply
Home
Forums
Low Earth Orbit
DIY Audio
60 Degree DIY Mid Hi - AKA PM60
Top
Bottom
Sign-up
or
log in
to join the discussion today!