Normal
Rhys thanks for the PM, you were looking for the pdf.try the link marked PM 60 belowPM 60I believe you could cut off the back corners off top and bottom without issue.the sides are not cut off but they do change angle towards the back just cutting them off would leave gaping spaces either side of the box as you see in Jim D's picture above.If you have tooling you could do this to the PM90 or 60's & add a piece there, 90's have a CAD drawing to go with however you could get those sides cnc cut if you have a CAD file with redone sides(If that is the right turn of phrase.
Rhys thanks for the PM, you were looking for the pdf.
try the link marked PM 60 below
PM 60
I believe you could cut off the back corners off top and bottom without issue.
the sides are not cut off but they do change angle towards the back just cutting them off would leave gaping spaces either side of the box as you see in Jim D's picture above.
If you have tooling you could do this to the PM90 or 60's & add a piece there, 90's have a CAD drawing to go with however you could get those sides cnc cut if you have a CAD file with redone sides(If that is the right turn of phrase.
