Normal
Probably by using rather fiddly ninety degree machined plywood joining strips which will be inserted between the skins into rebates where the core has been removed. The outer 4mm skins will be mitred at 45 degrees to keep it crisp and so no joints are visible on the edges. I'm also rather keen to make the horn exits with curved panels rather than joined flat sections. Crazy as it sounds, I've got a hankering after oiled purple-stained burr elm veneer finish; I don't really know where that one came from, but it just won't go away...I'm not yet quite up to speed on the joint details, but hey; at least I've got all the drivers, Neutrik 8-poles and cables, and enough crossovers and amps!
Probably by using rather fiddly ninety degree machined plywood joining strips which will be inserted between the skins into rebates where the core has been removed. The outer 4mm skins will be mitred at 45 degrees to keep it crisp and so no joints are visible on the edges. I'm also rather keen to make the horn exits with curved panels rather than joined flat sections. Crazy as it sounds, I've got a hankering after oiled purple-stained burr elm veneer finish; I don't really know where that one came from, but it just won't go away...
I'm not yet quite up to speed on the joint details, but hey; at least I've got all the drivers, Neutrik 8-poles and cables, and enough crossovers and amps!
