Normal
Today received the model of the XT1464. If i just put it in place same position as the BMS driver this is te result:[ATTACH=full]209261[/ATTACH][USER=652]@Peter Morris[/USER] , i saw you can lower the DCX464 mutch lower into the speakers in the PM90 post picture. Tomorrow the driver will arrive and i can make a model from wood to see how far the driver can be lowered and still safe distance of the 12 inch cones. From my point of vieuw it would be nicer not to use a spacer in the cabinets but adapt the cabinet to the horn. What is the rule i have to follow when i want to make the cut out fot the horn at the fron smaller? (30mm from front to 10mm for example)[ATTACH=full]209262[/ATTACH]Almost complete
Today received the model of the XT1464. If i just put it in place same position as the BMS driver this is te result:
[ATTACH=full]209261[/ATTACH]
[USER=652]@Peter Morris[/USER] , i saw you can lower the DCX464 mutch lower into the speakers in the PM90 post picture. Tomorrow the driver will arrive and i can make a model from wood to see how far the driver can be lowered and still safe distance of the 12 inch cones. From my point of vieuw it would be nicer not to use a spacer in the cabinets but adapt the cabinet to the horn. What is the rule i have to follow when i want to make the cut out fot the horn at the fron smaller? (30mm from front to 10mm for example)
[ATTACH=full]209262[/ATTACH]
Almost complete
