Normal
Re: Adding reverb to an IEM mixNot sure on the specifics of the Pro1, but on the X32 there is a way to get this done as follows:Create sends to the bus you are using as your various IEM mixes (just like you are now), but don't route these buses to any physical output.Use your matrix mixes (mixes of buses) to make a mix of the efx returns for the reverb in combination with the bus sends you are using for the IEM mixes.Route the matrix mix buses (which are now your monitor mixes) to the physical output you are using for the sends to your IEM transmitter(s).Hope this helps!
Re: Adding reverb to an IEM mix
Not sure on the specifics of the Pro1, but on the X32 there is a way to get this done as follows:
Create sends to the bus you are using as your various IEM mixes (just like you are now), but don't route these buses to any physical output.
Use your matrix mixes (mixes of buses) to make a mix of the efx returns for the reverb in combination with the bus sends you are using for the IEM mixes.
Route the matrix mix buses (which are now your monitor mixes) to the physical output you are using for the sends to your IEM transmitter(s).
Hope this helps!
