Reply to thread

Message

<blockquote data-quote="Rich Frembes" data-source="post: 58485" data-attributes="member: 432">Re: amp reconfirgure mode - what to do...I specified the gear on that stage way back when.&nbsp; Two fP10000Q did indeed power the FOH system, which consisted of four KF730 and two BH760 per side. Each pair of channels in one fP10000Q ran four lows and four mid/highs, each with a nominal four ohm load.&nbsp; Each pair of channels in the second fP10000Q ran two BH760s at a nominal 4 ohm load.We went with BH760s on that stage because of their high-ish sensitivity. They gave the most bang for the wattage buck, and watts were in short supply given that the rig was powered from solar panels / a bigass bank of marine batteries.Regarding using an fP10000Q for sub duties, my understanding (boy is that a loaded phrase) is that their power supply is happiest when only a few channels are tasked with high current demands, i.e. LF/LF/MF/HF or similar. This being said, I have successfully used the 10k for all-sub duties on numerous occasions, but I can definitely get a better sub sound using an fP14000 or similar.</blockquote>

[QUOTE="Rich Frembes, post: 58485, member: 432"] Re: amp reconfirgure mode - what to do... I specified the gear on that stage way back when. Two fP10000Q did indeed power the FOH system, which consisted of four KF730 and two BH760 per side. Each pair of channels in one fP10000Q ran four lows and four mid/highs, each with a nominal four ohm load. Each pair of channels in the second fP10000Q ran two BH760s at a nominal 4 ohm load. We went with BH760s on that stage because of their high-ish sensitivity. They gave the most bang for the wattage buck, and watts were in short supply given that the rig was powered from solar panels / a bigass bank of marine batteries. Regarding using an fP10000Q for sub duties, my understanding (boy is that a loaded phrase) is that their power supply is happiest when only a few channels are tasked with high current demands, i.e. LF/LF/MF/HF or similar. This being said, I have successfully used the 10k for all-sub duties on numerous occasions, but I can definitely get a better sub sound using an fP14000 or similar. [/QUOTE]

Verification