Reply to thread

Message

<blockquote data-quote="Jared Bartimus" data-source="post: 64265" data-attributes="member: 1478">Re: DH6-16 Compression driver in EV XI-1152/64Just in case someone has the same questions as I did in the future, this is the response from EV:&quot;As to the foam on the compression driver – this was used to damp a resonance this driver’s nose cone created in the cabinet.&nbsp; Engineering said to just try and push the foam back into the crevice and it should be fine.&nbsp; If the foam is starting to break down just replace with something similar, it is not a specific foam.&quot;There is a rectangle at the back of the horn, if it is vertical then the drivers are in 60x40.&nbsp; Also, if the horn looks like it does on the site/EDS it is 60x40.</blockquote>

[QUOTE="Jared Bartimus, post: 64265, member: 1478"] Re: DH6-16 Compression driver in EV XI-1152/64 [COLOR=#000000][FONT=Verdana]Just in case someone has the same questions as I did in the future, this is the response from EV:[/FONT][/COLOR] [COLOR=#000000][FONT=Verdana]"As to the foam on the compression driver – this was used to damp a resonance this driver’s nose cone created in the cabinet. Engineering said to just try and push the foam back into the crevice and it should be fine. If the foam is starting to break down just replace with something similar, it is not a specific foam."[/FONT][/COLOR] [COLOR=#000000][FONT=Verdana]There is a rectangle at the back of the horn, if it is vertical then the drivers are in 60x40. Also, if the horn looks like it does on the site/EDS it is 60x40. [/FONT][/COLOR] [/QUOTE]

Verification