Reply to thread

Message

<blockquote data-quote="Spenser Hamilton" data-source="post: 217319" data-attributes="member: 2272">Our SD9 has been flawless, but we follow recommended protocol (proper shutdown, reload show file at start up, starting new gigs from scratch - or at least from a template).About a year ago I had an SD12 go down in the middle of a set due to a bad UPS, the desk came back up seemingly okay but after closer inspection the channel routing had shifted by one, causing some weirdness with stereo inputs feeding stereo iem mixes. The artist only had a few songs left as I was able to clean things up on the fly enough that they could finish. After their set we were loading the headliners show file anyways.I would assume that by never performing a proper shutdown and boot up one would be risking a similar scenario (show file corruption) which could consequences ranging from minor (as I experienced) to major.What is going on with the PA that makes it so hard to create a file from scratch? Could a partial load into a fresh show file be used to get around this (ie partial load the matrix section only)?</blockquote>

[QUOTE="Spenser Hamilton, post: 217319, member: 2272"] Our SD9 has been flawless, but we follow recommended protocol (proper shutdown, reload show file at start up, starting new gigs from scratch - or at least from a template). About a year ago I had an SD12 go down in the middle of a set due to a bad UPS, the desk came back up seemingly okay but after closer inspection the channel routing had shifted by one, causing some weirdness with stereo inputs feeding stereo iem mixes. The artist only had a few songs left as I was able to clean things up on the fly enough that they could finish. After their set we were loading the headliners show file anyways. I would assume that by never performing a proper shutdown and boot up one would be risking a similar scenario (show file corruption) which could consequences ranging from minor (as I experienced) to major. What is going on with the PA that makes it so hard to create a file from scratch? Could a partial load into a fresh show file be used to get around this (ie partial load the matrix section only)? [/QUOTE]

Verification