Reply to thread

Message

<blockquote data-quote="Jake Scudder" data-source="post: 31783" data-attributes="member: 195">Re: DM2000 &quot;VCA&#039;s&quot;&nbsp;Fader Groups are different than your normal audio groups. All outputs will still be available.I&#039;m not sure about pairing. I see no reason it would be impacted by the use of groups.It can be a little tricky to get the groups to populate properly over multiple scenes. If I&#039;m remembering correctly the combination of recall safe selections is not very intuitive. Sorry I can&#039;t be more specific, it&#039;s been a few years.&nbsp; It&#039;s very tedious to program this way but I&#039;ve done it for some fairly large musicals. I used the middle bank of 8 and then assigned reverbs and anything else I wanted on a fader to the remote layer on either side. I wish you could rename the groups but you can&#039;t so I would suggest some labels.Jake</blockquote>

[QUOTE="Jake Scudder, post: 31783, member: 195"] Re: DM2000 "VCA's" Fader Groups are different than your normal audio groups. All outputs will still be available. I'm not sure about pairing. I see no reason it would be impacted by the use of groups. It can be a little tricky to get the groups to populate properly over multiple scenes. If I'm remembering correctly the combination of recall safe selections is not very intuitive. Sorry I can't be more specific, it's been a few years. It's very tedious to program this way but I've done it for some fairly large musicals. I used the middle bank of 8 and then assigned reverbs and anything else I wanted on a fader to the remote layer on either side. I wish you could rename the groups but you can't so I would suggest some labels. Jake [/QUOTE]

Verification