Reply to thread

Message

<blockquote data-quote="Joris Wijgerde" data-source="post: 213486" data-attributes="member: 13728">Thank you for sharing this Peter.I actually have been looking at ways to cross an efficient 12&quot; with my BMS 4592 over some 15&quot; kickbins; but reading this thread I&#039;m wondering whether it wouldn&#039;t be an option to just take the more straightforward route and just use double 15&#039;s, ditching the kickbins.The drivers I have are Eminence Kappa Pro LF2&#039;s, and I would like to couple the 4592ND with the official BMS 2236 horn (60x40°) in trap cabinets so if needed I can splay them horizontally in pairs. These cabinets would be used in stacks, on top of tapped horns which run up to 90Hz.The processing available is an XTA DP446 with powersoft k-series amps.I realize that these drivers aren&#039;t top of the line, but since I already have a whole bunch of them it would be nice if they could be used. If not, do you think getting a different driver (like the FaitalPro, suggestions welcome) would still be a better option than going the 15&quot; kick + 12&quot; mid route? It would definitely make for a simpler build and setup.Any advice?</blockquote>

[QUOTE="Joris Wijgerde, post: 213486, member: 13728"] Thank you for sharing this Peter. I actually have been looking at ways to cross an efficient 12" with my BMS 4592 over some 15" kickbins; but reading this thread I'm wondering whether it wouldn't be an option to just take the more straightforward route and just use double 15's, ditching the kickbins. The drivers I have are Eminence Kappa Pro LF2's, and I would like to couple the 4592ND with the official BMS 2236 horn (60x40°) in trap cabinets so if needed I can splay them horizontally in pairs. These cabinets would be used in stacks, on top of tapped horns which run up to 90Hz. The processing available is an XTA DP446 with powersoft k-series amps. I realize that these drivers aren't top of the line, but since I already have a whole bunch of them it would be nice if they could be used. If not, do you think getting a different driver (like the FaitalPro, suggestions welcome) would still be a better option than going the 15" kick + 12" mid route? It would definitely make for a simpler build and setup. Any advice? [/QUOTE]

Verification