Log in
Register
Home
Forums
New posts
Search forums
What's new
Featured content
New posts
New profile posts
Latest activity
News
Members
Current visitors
New profile posts
Search profile posts
Features
Log in
Register
What's new
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Menu
Install the app
Install
Reply to thread
Home
Forums
Low Earth Orbit
Lighting & Electrical
Favorite claws/clamps for small fixtures?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="TJ Cornish" data-source="post: 35833" data-attributes="member: 162"><p>Re: Favorite claws/clamps for small fixtures?</p><p></p><p>Thanks for the thoughts folks! Though I would happily spend $22/fixture, or even the $26 that Mega Claws cost if that was the clearly the best answer, I'm going to give the Global Truss Mini-360s a try. I'm sure structurally it will be perfectly adequate for holding my whopping 6 lb LED fixtures, and for 1/3 the cost of the heavier/fancier clamps. My only concerns were the ease of adequately tightening the wing nut any any ergonomic issues these may have that would piss me off over time. Sounds like some folks have used these with good success. I like that the fixture mount side of the clamp is a wing nut too which will make it easy to take off when I switch to T-bar mode.</p></blockquote><p></p>
[QUOTE="TJ Cornish, post: 35833, member: 162"] Re: Favorite claws/clamps for small fixtures? Thanks for the thoughts folks! Though I would happily spend $22/fixture, or even the $26 that Mega Claws cost if that was the clearly the best answer, I'm going to give the Global Truss Mini-360s a try. I'm sure structurally it will be perfectly adequate for holding my whopping 6 lb LED fixtures, and for 1/3 the cost of the heavier/fancier clamps. My only concerns were the ease of adequately tightening the wing nut any any ergonomic issues these may have that would piss me off over time. Sounds like some folks have used these with good success. I like that the fixture mount side of the clamp is a wing nut too which will make it easy to take off when I switch to T-bar mode. [/QUOTE]
Insert quotes…
Verification
Post reply
Home
Forums
Low Earth Orbit
Lighting & Electrical
Favorite claws/clamps for small fixtures?
Top
Bottom
Sign-up
or
log in
to join the discussion today!
