Reply to thread

Message

Since I didn't know about APL C5, I followed your approach but for APL Workshop - Defining per Driver Target Curves, then measure the drivers seperately (either with or without IIR-crossovers) and then combine them and correct possible phase issues in the crossover region with delay/allpass filters. Results are good so far, although I haven't been able to recreate a TDA graph that comes close to Peter Morris results.

[QUOTE="jami schorling, post: 216858, member: 13511"] Since I didn't know about APL C5, I followed your approach but for APL Workshop - Defining per Driver Target Curves, then measure the drivers seperately (either with or without IIR-crossovers) and then combine them and correct possible phase issues in the crossover region with delay/allpass filters. Results are good so far, although I haven't been able to recreate a TDA graph that comes close to Peter Morris results. [/QUOTE]

Verification