I have four Meyer Sound Ultra Series USW1 Subwoofers up for grabs. They all function perfectly and have had the drivers updated as needed, there are no re-cones in this set. I used them for theatre rentals and corporate events so the drivers have very low hours.
The USW-1 Subwoofer is a dual 15" cabinet that matches with the Meyer UPA. It's passive so it requires the B2a processor and appropriate amplifier. The boxes are internally wired for 4 loads via an NL4 connector on the rear. Pins 1 and 2 (1+, 1-) are wired parallel so the other pins are unused. I have new foam grills for two of them, but opted to cover the grills with AcousTex fabric in order to simplify the look and set-up. If you have used them and had to transport them you know how hard it to keep the foam looking good so I never installed the new pieces. I'm currently using a Crown XTI2000 per pair of subs and the processor controls the power via the sense cable (second stage limiting). It was my intention to paint them with some sort of bed liner, but never got that far along, they were typically hidden by stage skirts. You will probably want to paint them.
I'm asking $800 per pair and that includes one B2A processor for each pair.
Feel free to make me an offer for all four sub cabinets and two processors.
First buyer of a pair gets the foam.
The subs are located in Lawrenceville, GA but can assist in the delivery. Cash is preferred, PayPal is acceptable too but you would be responsible for the service charge fees.
email: kip[at]shawnmullins.com with any questions.
The USW-1 Subwoofer is a dual 15" cabinet that matches with the Meyer UPA. It's passive so it requires the B2a processor and appropriate amplifier. The boxes are internally wired for 4 loads via an NL4 connector on the rear. Pins 1 and 2 (1+, 1-) are wired parallel so the other pins are unused. I have new foam grills for two of them, but opted to cover the grills with AcousTex fabric in order to simplify the look and set-up. If you have used them and had to transport them you know how hard it to keep the foam looking good so I never installed the new pieces. I'm currently using a Crown XTI2000 per pair of subs and the processor controls the power via the sense cable (second stage limiting). It was my intention to paint them with some sort of bed liner, but never got that far along, they were typically hidden by stage skirts. You will probably want to paint them.
I'm asking $800 per pair and that includes one B2A processor for each pair.
Feel free to make me an offer for all four sub cabinets and two processors.
First buyer of a pair gets the foam.
The subs are located in Lawrenceville, GA but can assist in the delivery. Cash is preferred, PayPal is acceptable too but you would be responsible for the service charge fees.
email: kip[at]shawnmullins.com with any questions.