Reply to thread

Message

<blockquote data-quote="Terry Fryar" data-source="post: 31136" data-attributes="member: 501">Re: Good weekend and Lake questionYeh Evan...it&#039;s a wierd one. There is no muting at all, and the settings are all there as if nothing happened!&nbsp; I even removed the module and recreated it to no avail!&nbsp; I can even watch the sub input channel getting signal, and the output meter right next to it has no signal....straaange!&nbsp; I know after trying either a preset recall or some other type of change, it eventually pops the red box up that says &quot;out of sync&quot;. I think it might be a firmware bug, as I&#039;ve never had any of the other channels go away...only the R sub output. Also, it takes several minutes of network problems before this happens. I can have a few network glitches and the lake is still ok. Plus, since I&#039;ve got a mix of FIR and IIR, it&#039;s a bit of wierd configuration for a lake, but it works just fine. I had to switch out of FIR for the subs since it&#039;s such low frequencies...I don&#039;t have enough CPU (or time!) left in the DSP to do 4 way stereo FIR. The sub section ended up using IIR Linkwitz filters...which is fine. Given their placement, I have to phase align em anyway, so it&#039;s not a big deal...&nbsp;I&#039;ve got 5 wireless bridges that I use that are similar to the famous WRT54 routers, but with stronger radios. I use OpenWRT linux on em and they do quite well, but at this show I had about 3 folks stepping on my channel. After I changed to a clear channel, all was well! That&#039;s what I get being lazy on sniffing the area before I set up! ;-) I think if I just make sure the network is clear...I&quot;ll be good on the lake. Heck, we could even hardwire I guess. I just wanted to see if anyone had run across this before? I always end up with the strange stuff!</blockquote>

[QUOTE="Terry Fryar, post: 31136, member: 501"] Re: Good weekend and Lake question Yeh Evan...it's a wierd one. There is no muting at all, and the settings are all there as if nothing happened! I even removed the module and recreated it to no avail! I can even watch the sub input channel getting signal, and the output meter right next to it has no signal....straaange! I know after trying either a preset recall or some other type of change, it eventually pops the red box up that says "out of sync". I think it might be a firmware bug, as I've never had any of the other channels go away...only the R sub output. Also, it takes several minutes of network problems before this happens. I can have a few network glitches and the lake is still ok. Plus, since I've got a mix of FIR and IIR, it's a bit of wierd configuration for a lake, but it works just fine. I had to switch out of FIR for the subs since it's such low frequencies...I don't have enough CPU (or time!) left in the DSP to do 4 way stereo FIR. The sub section ended up using IIR Linkwitz filters...which is fine. Given their placement, I have to phase align em anyway, so it's not a big deal... I've got 5 wireless bridges that I use that are similar to the famous WRT54 routers, but with stronger radios. I use OpenWRT linux on em and they do quite well, but at this show I had about 3 folks stepping on my channel. After I changed to a clear channel, all was well! That's what I get being lazy on sniffing the area before I set up! ;-) I think if I just make sure the network is clear...I"ll be good on the lake. Heck, we could even hardwire I guess. I just wanted to see if anyone had run across this before? I always end up with the strange stuff! [/QUOTE]

Verification