Normal
Re: Here's the picture you ALL have been waiting forI'm testing a Dynacord PowerH 5000 right now, I'ts a pretty impressive amp. It runs all four labs flawlessy in 2.1 ohms according to it's load monitor. I've confirmend my initial delay setting of 5ms, I have to use 7 ms with the Dynacord due to it's internal dsp. I also did some testing of different lo-cut filters, it seems like a 30 hz 24 db butterworth is a pretty good compromise between performance and protection.Silas: I know that you were using Itechs on your subs, and the limiter section in the Dynacord is pretty similar to that of an Itech. What did you use as limiter settings? I currently limit them at 58v RMS, 82v peak in 2 ohm.
Re: Here's the picture you ALL have been waiting for
I'm testing a Dynacord PowerH 5000 right now, I'ts a pretty impressive amp. It runs all four labs flawlessy in 2.1 ohms according to it's load monitor. I've confirmend my initial delay setting of 5ms, I have to use 7 ms with the Dynacord due to it's internal dsp. I also did some testing of different lo-cut filters, it seems like a 30 hz 24 db butterworth is a pretty good compromise between performance and protection.
Silas: I know that you were using Itechs on your subs, and the limiter section in the Dynacord is pretty similar to that of an Itech. What did you use as limiter settings? I currently limit them at 58v RMS, 82v peak in 2 ohm.
