Normal
Re: How much does orientation of sub cabinets matter?Sometimes I do, in this case this was unwrapped enough. If I were trying to do math to figure out how many degrees off one bandpass was from another I would definitely flatten it out. In this case I just added or subtracted a few orders of filter until the slopes were close and then used delay to line them up. The ends do justify the means!The stuff going on at 300Hz is a ground bounce, I was only worrying about my mains/sub crossover so I didn't bother taking a wide-bandwidth measurement (and often don't).
Re: How much does orientation of sub cabinets matter?
Sometimes I do, in this case this was unwrapped enough. If I were trying to do math to figure out how many degrees off one bandpass was from another I would definitely flatten it out. In this case I just added or subtracted a few orders of filter until the slopes were close and then used delay to line them up. The ends do justify the means!
The stuff going on at 300Hz is a ground bounce, I was only worrying about my mains/sub crossover so I didn't bother taking a wide-bandwidth measurement (and often don't).
