I managed to snag a couple of pretty decent looking 600:600 ohm output transformers from a piece of equipment and I would like to make something along the lines of a Radial Twin-ISO. I've go the box, connectors, etc. all figured out, I'm just trying to figure out the wiring. I wanted to keep it simple.
The schematic on the Jensen site for their iso boxes shows some resistors and caps in parallel with the transformer, but I am not entirely sure what these are for. Some sort of impedance correction?
Is it as simple as connecting the input and output leads of the transformer to a set of XLR's and calling it a day, or should there be some other components?
FWIW, these are not the Jensen's. Just some generic transformers from a piece of audio equipment.
The schematic on the Jensen site for their iso boxes shows some resistors and caps in parallel with the transformer, but I am not entirely sure what these are for. Some sort of impedance correction?
Is it as simple as connecting the input and output leads of the transformer to a set of XLR's and calling it a day, or should there be some other components?
FWIW, these are not the Jensen's. Just some generic transformers from a piece of audio equipment.