Reply to thread

Message

I need to measure the output of an amplifier, so I would like to build an adapter from Speakon to XLR, and preferably be clever enough to fit the pad in the adapter. Assuming I want 32dB of attenuation, am I good just using 570 and 30 ohm resistors? How much power will the amplifier develop into 30 ohms (assuming I do not need to observe its behavior at maximum output)?

[QUOTE="Bennett Prescott, post: 2531, member: 4"] I need to measure the output of an amplifier, so I would like to build an adapter from Speakon to XLR, and preferably be clever enough to fit the pad in the adapter. Assuming I want 32dB of attenuation, am I good just using 570 and 30 ohm resistors? How much power will the amplifier develop into 30 ohms (assuming I do not need to observe its behavior at maximum output)? [/QUOTE]

Verification

Top Bottom