Reply to thread

Message

<blockquote data-quote="Randy Gartner" data-source="post: 76806" data-attributes="member: 104">Re: Midas Pro1 TutorialOk folks,I have plenty of questions. When I first picked up the board,I would get an input signal on the meter when I plugged a mic into channel 1.&nbsp; &nbsp; Now I get nothing. The LED lights on the back are lit on the output side,but not on the input ides.That makes me think that I have them sourced from the stage box.How do I get them back on the surface? Even when I had the input working,I was getting no out put.No meters,no sound. Once you let me know how to get the surface inputs working,then how do I route say channel 1 to the out puts? Evan had told me to go to automation and recall the safe scene.But I see no recall for safe scene.I see a recall slope.Where do I recall the safe scene? He also suggested going to patching then click the busses tab on the &quot;from&quot; side and the I/O tab on the &quot;to&quot; side which I did.Then he says to make sure the outputs are patched to the surface but I&#039;m not seeing where to do this.He says click on the grey box below the L. I don&#039;t see an &quot;L&quot;.I&#039;m obviously missing something or maybe the Pro 1 is a little different from the bigger ones.A few more questions.At the top above the channel controls is a direct mute button.it seems to be lit and no matter what I try It doesn&#039;t go off.Maybe that&#039;s part of the problem.How does that work and what does it do? Also,on the screen,there is a status button that is red.What does that mean.Right now I&#039;m just trying to get audio out of the board so any help would be appreciated.Just keep it simple.Thanks.</blockquote>

[QUOTE="Randy Gartner, post: 76806, member: 104"] Re: Midas Pro1 Tutorial Ok folks,I have plenty of questions. When I first picked up the board,I would get an input signal on the meter when I plugged a mic into channel 1. Now I get nothing. The LED lights on the back are lit on the output side,but not on the input ides.That makes me think that I have them sourced from the stage box.How do I get them back on the surface? Even when I had the input working,I was getting no out put.No meters,no sound. Once you let me know how to get the surface inputs working,then how do I route say channel 1 to the out puts? Evan had told me to go to automation and recall the safe scene.But I see no recall for safe scene.I see a recall slope.Where do I recall the safe scene? He also suggested going to patching then click the busses tab on the "from" side and the I/O tab on the "to" side which I did.Then he says to make sure the outputs are patched to the surface but I'm not seeing where to do this.He says click on the grey box below the L. I don't see an "L". I'm obviously missing something or maybe the Pro 1 is a little different from the bigger ones. A few more questions.At the top above the channel controls is a direct mute button.it seems to be lit and no matter what I try It doesn't go off.Maybe that's part of the problem.How does that work and what does it do? Also,on the screen,there is a status button that is red.What does that mean.Right now I'm just trying to get audio out of the board so any help would be appreciated.Just keep it simple.Thanks. [/QUOTE]

Verification