Reply to thread

Message: <blockquote data-quote="Jimmy Hardin" data-source="post: 207918" data-attributes="member: 3644">Correct me if I am wrong, and I very well may be. Let me see if I got this straight , you are wanting to take a power amp and put 2 unpowered monitors and one powered monitor on one channel so you will all get the same signal path? If so, how low will your power amp go. I think if my calculations are correct you will be going down to a 2.6 ohm load if this amp will take a 2 ohm load then you should be fine but if the lowest load is a 4 ohm load then I wouldn’t advise it. Now , on the powered speaker if you are running a power amp into a powered speaker you are going to blow the amp inside the powered speaker. I would put three unpowered speaker cabs on the power amp . Sent from my iPhone</blockquote>

Top Bottom