Normal
Re: New DIY Mid HighHi Spenser,I actually did this trick with the outer horn (below). I spaced the cuts at increasing intervals so I could approximate the exponential curve I needed. Having said that its not that critical, the difference between a conical horn, an exponential horn, and an exponential horn made of conical sections is not that much.The other thing to note is that if you make a 60 degree version you will need to make it a little deeper. Also note the clearance between the compression driver and the 12" is very small. It fits between the spokes of the 12" frame - you must check this all fits.
Re: New DIY Mid High
Hi Spenser,
I actually did this trick with the outer horn (below). I spaced the cuts at increasing intervals so I could approximate the exponential curve I needed. Having said that its not that critical, the difference between a conical horn, an exponential horn, and an exponential horn made of conical sections is not that much.
The other thing to note is that if you make a 60 degree version you will need to make it a little deeper. Also note the clearance between the compression driver and the 12" is very small. It fits between the spokes of the 12" frame - you must check this all fits.
