Log in
Register
Home
Forums
New posts
Search forums
What's new
Featured content
New posts
New profile posts
Latest activity
News
Members
Current visitors
New profile posts
Search profile posts
Features
Log in
Register
What's new
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Menu
Install the app
Install
Reply to thread
Home
Forums
Low Earth Orbit
DIY Audio
New DIY Mid High (90deg) - AKA PM90
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Peter van Gils" data-source="post: 202616" data-attributes="member: 3943"><p>Did you check the ribbon cable from the mainboard to the IO board in the DCX? This ribbon cable carries the audio signals with some DC voltage: they are known to have bad connectors. (Connection between cable and connector is bad.) It starts with noise/his and eventually drop outs on channels. I have 3 of these units, all with the same problem. I soldered the ribbon cable to the IO board and replaced the connector on the cable at the main board side. No issues since then...</p></blockquote><p></p>
[QUOTE="Peter van Gils, post: 202616, member: 3943"] Did you check the ribbon cable from the mainboard to the IO board in the DCX? This ribbon cable carries the audio signals with some DC voltage: they are known to have bad connectors. (Connection between cable and connector is bad.) It starts with noise/his and eventually drop outs on channels. I have 3 of these units, all with the same problem. I soldered the ribbon cable to the IO board and replaced the connector on the cable at the main board side. No issues since then... [/QUOTE]
Insert quotes…
Verification
Post reply
Home
Forums
Low Earth Orbit
DIY Audio
New DIY Mid High (90deg) - AKA PM90
Top
Bottom
Sign-up
or
log in
to join the discussion today!
