Reply to thread

Message

<blockquote data-quote="Vishnu Kannie" data-source="post: 146052" data-attributes="member: 10119">Re: Nexo PS8 &amp; LS400 - no matching sub or amps - WHAT TO DO NOWThank you Rob &amp; Gary, much appreciated on the advice. Please excuse me if I may come off being a little blond, but may I clarify the system flow, so I get it right:-CDJ/ DJ mixer -&gt; active crossover (Behringer 3 way crossover) -&gt; Nexo PS TD controller -&gt; amp -&gt; PS8&#039;s &amp; subPS8 -&gt; the MID output from the Behringer will go into the input of Nexo PS TD controller and then the output from there will go into the amp, then speakers. (would I still need to connect &amp; use the sensitivity feature on the PS controller)Sub -&gt; the sub output from the Behringer will go straight into the amp, then sub.Can this above flow (as a passive system), work using only 1 amp to power the PS8&#039;s (on 4 Ohm load) on one channel and the sub (either 4 or 8 Ohm load) on the other.</blockquote>

[QUOTE="Vishnu Kannie, post: 146052, member: 10119"] Re: Nexo PS8 & LS400 - no matching sub or amps - WHAT TO DO NOW Thank you Rob & Gary, much appreciated on the advice. Please excuse me if I may come off being a little blond, but may I clarify the system flow, so I get it right:- CDJ/ DJ mixer -> active crossover (Behringer 3 way crossover) -> Nexo PS TD controller -> amp -> PS8's & sub [U][B]PS8 -> [/B][/U]the MID output from the Behringer will go into the input of Nexo PS TD controller and then the output from there will go into the amp, then speakers. (would I still need to connect & use the sensitivity feature on the PS controller) [U][B]Sub -> [/B][/U]the sub output from the Behringer will go straight into the amp, then sub. Can this above flow (as a passive system), work using only 1 amp to power the PS8's (on 4 Ohm load) on one channel and the sub (either 4 or 8 Ohm load) on the other. [/QUOTE]

Verification