Re: No compromises front loaded double 18” cab
Progress has been made! I cut out everything and have dry fitted the box together, It looks pretty nice, All I have left to do is ports, witch I am trying to figure out how I will be able to adjust the depth on until I Know what I need, I may just make the 10" ports to start and assemble the box entirely with glue, but only screw in the ports in so that I can get in and remove them to adjust length.
Simon, I am dividing the box in two with the center divider that is between the ports. I am not too sure about efficiency, but that was not the greatest concern to me. I did the simulation on a friends PC. I need to get a cheap used laptop so that I can go back to it, and to use the Dayton testing device that came in the mail a few days ago. I am all Mac and Paralells was not running the software too well....
Here are some pics of day one of construction
I found it easiest for my baffle design to cut some blanks out of cardboard to lay them out on the plywood, I roughed them out with a saber saw, and then made a jig for the table saw to cut the angles. The last shot just shows the lap joints that are used all over the box for a better seal.
[ATTACH]153878[/ATTACH][ATTACH]153879[/ATTACH][ATTACH]153880[/ATTACH][ATTACH]153881[/ATTACH][ATTACH]153882[/ATTACH]
