Reply to thread

Question:


I notice upon close examination of the cabbnet design and photos that the Ciare horn is not centered in the width of the front baffle with the 12” drivers, it seems maybe 2-2.5cm off to ine side from the centered 12s. I assume its for the Comp driver against the 25degree side? What consequences does this offset pose to the patterns between the LF and Coax and cohesiveness between them?


My other question is:


When you splay three boxes at the 25 degrees per side, what happens to the overall pattern that is closer and less than the 60degree horizontal pattern? If the signals are overlapping and not seperated by a full 60degrees (30 degrees per side) will there be any comb filtering? Is the overall coverage in the horizontal then 150 degrees?


Thanks Peter.



Sent from my iPhone