Normal
Possibly, but did he confirm the negative wasn't going to ground with continuity measurements before replacing the caps "backwards" before doing it ? Because as Brian mentioned at the beginning of this forum thread, it's just older ones that MIGHT need them "reversed".I believe he also posted pictures of the ones in question, not all caps are the issue. They show the actual bulging caps, it's a TM8, but still same area. I compared one of our older ones with one of our newer ones, and he is correct. And an authorized QSC service center told him this.Did you end up doing that factory reset ?
Possibly, but did he confirm the negative wasn't going to ground with continuity measurements before replacing the caps "backwards" before doing it ? Because as Brian mentioned at the beginning of this forum thread, it's just older ones that MIGHT need them "reversed".
I believe he also posted pictures of the ones in question, not all caps are the issue. They show the actual bulging caps, it's a TM8, but still same area.
I compared one of our older ones with one of our newer ones, and he is correct. And an authorized QSC service center told him this.
Did you end up doing that factory reset ?
