Reply to thread

Message

Hi, have a TM16 SN: LLE0G266. Caps are bulged and mains are noisy. Thank you for posting this issue.
Because there are 2 caps on the mains I was checking which pin connected to what.
Looking at the bottom of the board with the output XLR's to the top, Right or Left Main, the Left Cap, right leg goes to XLR pin 3, while the Right Cap, right leg goes to XLR pin 2.
Does this suggest that the left cap should be the opposite polarity of the right cap being that XLR pin 3 is the - signal or just reverse both of them?
Thanks

[QUOTE="Peter Gaff, post: 217552, member: 16141"] Hi, have a TM16 SN: LLE0G266. Caps are bulged and mains are noisy. Thank you for posting this issue. Because there are 2 caps on the mains I was checking which pin connected to what. Looking at the bottom of the board with the output XLR's to the top, Right or Left Main, the Left Cap, right leg goes to XLR pin 3, while the Right Cap, right leg goes to XLR pin 2. Does this suggest that the left cap should be the opposite polarity of the right cap being that XLR pin 3 is the - signal or just reverse both of them? Thanks [/QUOTE]

Verification