Normal
Maybe someone here can help me out. I'm spec'ing out an install where we will use a Samson S zone mixer. It has euroblock inputs labelled "Line" and "Mic". The "Line" ins are for consumer grade (-10dbv) gear and the connections are labelled Left/Right/Ground. The Mic level ins are labelled +/-/ground. There is a level control for each of the Mic level ins, so I'm hoping that the sub mixers connected to each of the Mic ins aren't going to be too hot.If I were to need to use the "Line" ins to connect an actual line level device what steps would I need to take. Fist I would assume I need to pad the signal down, and then I would need to get it to a unbalanced configuration. The terms they use in the manual are misleading. "Line in" should mean "balanced line level in".BJ
Maybe someone here can help me out. I'm spec'ing out an install where we will use a Samson S zone mixer. It has euroblock inputs labelled "Line" and "Mic". The "Line" ins are for consumer grade (-10dbv) gear and the connections are labelled Left/Right/Ground. The Mic level ins are labelled +/-/ground. There is a level control for each of the Mic level ins, so I'm hoping that the sub mixers connected to each of the Mic ins aren't going to be too hot.
If I were to need to use the "Line" ins to connect an actual line level device what steps would I need to take. Fist I would assume I need to pad the signal down, and then I would need to get it to a unbalanced configuration. The terms they use in the manual are misleading. "Line in" should mean "balanced line level in".
BJ
