SRX818 Crossover question

[Ben Lawrence]

So I was doing a little test around with my SRX 818 sub today with a pair of PRX712 for a little BBQ Im providing for tomorrow. Previous gigs I was running into a Driverack with a pair of SRX715s with good results. It appeared as though the 80hz,100hz.120hz presets on the sub do not affect the signal output of the mixer. So I am just looking for confirmation these have no hi pass filter on the output? I have not gotten into the software where Im hoping this can be adjusted. For tomorrow I guess I will just plan on patching thru my driverack. I think I will want a 40hz low end cut on the subs anyhow for safety.

 

[Tim McCulloch]

The outputs on the SRX800SP series are not processed - they are a direct Y split of the input signal.

 

[Debbie dunkley]

 

[Debbie dunkley]

I tried to post page 28 from the SRX manual but I suppose it didn't work.

https://www.jblpro.com/ProductAttachments/SRX800_UsersGuide_061515.pdf

 

[Ben Lawrence]

I just downloaded the software. It would be great if I could enable those outputs to be a hi pass to go direct to a set of tops.

 

[Ben Lawrence]

Sooo I think I might need to look at a couple videos of this config. It looks like this software is really designed specifically for matching 800 series stuff. The only controls I see coming up directly are Eq, compression and delay. Thinking this might not be the best solution for a pair of subs and different series tops. Looks like I would have to move from my 715s to 815s to utilize correctly.