Reply to thread

Message

Re: Virtual SMAART training: Tell the crossover frequency and type

Hi Jason,

this is a 12"/1" measured on axis and off axis ( means below the 12" driver, path length difference compared to on axis is about 6cm )

here you can see what Systune displays without additional windowing

Uwe

[QUOTE="Uwe Riemer, post: 39966, member: 394"] Re: Virtual SMAART training: Tell the crossover frequency and type [IMG]http://go2convert.com/converted/download/LaWBcUmO[/IMG] Hi Jason, this is a 12"/1" measured on axis and off axis ( means below the 12" driver, path length difference compared to on axis is about 6cm ) here you can see what Systune displays without additional windowing Uwe [/QUOTE]

Verification

Top Bottom