Reply to thread

Message

<blockquote data-quote="Helge A. Bentsen" data-source="post: 3376" data-attributes="member: 263">I ran into a problem today using one of my computers running Win7 when I tried to measure two different signals with the internal generator as reference. I could&#039;nt get both inputs to display the same delay time when I looped pinknoise directly from output to both inputs. After an frustrating hour messing around with different settings I finally discovered that Smaart was running at 48K, but the playback and recording settings in Windows was 44.1K. Changed that to 48K, and everything was fine. Just a tip so you don&#039;t have to waste an hour like I did....On another note: On a Vi1, if you run a channel through a group and then on to L/R, the latency difference is 0.25ms compared to running the same channel directly to L/R. This is without any processing on the group.If you insert something in the analog domain on the same group, using the groups insert point and a line out/line in, the latency increases to 0.98ms.I forgot to measure if the latency increases on the group if you use any kind of processing on it, have to do that next time.</blockquote>

[QUOTE="Helge A. Bentsen, post: 3376, member: 263"] I ran into a problem today using one of my computers running Win7 when I tried to measure two different signals with the internal generator as reference. I could'nt get both inputs to display the same delay time when I looped pinknoise directly from output to both inputs. After an frustrating hour messing around with different settings I finally discovered that Smaart was running at 48K, but the playback and recording settings in Windows was 44.1K. Changed that to 48K, and everything was fine. Just a tip so you don't have to waste an hour like I did.... On another note: On a Vi1, if you run a channel through a group and then on to L/R, the latency difference is 0.25ms compared to running the same channel directly to L/R. This is without any processing on the group. If you insert something in the analog domain on the same group, using the groups insert point and a line out/line in, the latency increases to 0.98ms. I forgot to measure if the latency increases on the group if you use any kind of processing on it, have to do that next time. [/QUOTE]

Verification