Reply to thread

Message

<blockquote data-quote="Shane Presley" data-source="post: 138750" data-attributes="member: 110">Re: X32, DCAs, Groups, etc.You have alot going on here Todd that is unconventional to me, but maybe it works for you.&nbsp; I have no experience with the P16 system, or how it reacts but from what I can see from your routing - you are using ch9 of the P16 as your &quot;drum group&quot; send to the P16.&nbsp; Raising and lowering the dca assigned to drums will affect the group level, becuase the dca is basically &quot;raising and lowering&quot; the channel volumes contributing to the group.&nbsp; it is also assigned as pre EQ, not pre fader - which again, not sure how that affects the sends... but I would go back and assign ALL P16 routing to pre fader as instructed earlier in the thread (ch 1 is set pre EQ, not pre fader).&nbsp; Also some general tips... use your highpass filters more on your channels instead of carving the bottom end out with EQ ( EG your overheads have no highpass on, and yet the low eq is dragged out) Some might argue 6 and half a dozen but... On your snare a highpass of 400hz , but 20hz on your 1st tom... Also what is group 4 doing as it doesn&#039;t seem to be crowd ambient mics (not assigned to P16), nor is it assinged to L&amp;R... same goes for group 5 ( what is band co?) - no channels are assinged to buss 5...</blockquote>

[QUOTE="Shane Presley, post: 138750, member: 110"] Re: X32, DCAs, Groups, etc. You have alot going on here Todd that is unconventional to me, but maybe it works for you. I have no experience with the P16 system, or how it reacts but from what I can see from your routing - you are using ch9 of the P16 as your "drum group" send to the P16. Raising and lowering the dca assigned to drums will affect the group level, becuase the dca is basically "raising and lowering" the channel volumes contributing to the group. it is also assigned as pre EQ, not pre fader - which again, not sure how that affects the sends... but I would go back and assign ALL P16 routing to pre fader as instructed earlier in the thread (ch 1 is set pre EQ, not pre fader). Also some general tips... use your highpass filters more on your channels instead of carving the bottom end out with EQ ( EG your overheads have no highpass on, and yet the low eq is dragged out) Some might argue 6 and half a dozen but... On your snare a highpass of 400hz , but 20hz on your 1st tom... Also what is group 4 doing as it doesn't seem to be crowd ambient mics (not assigned to P16), nor is it assinged to L&R... same goes for group 5 ( what is band co?) - no channels are assinged to buss 5... [/QUOTE]

Verification