Reply to thread

Message

<blockquote data-quote="Michael John" data-source="post: 42997" data-attributes="member: 830">Re: Yamaha MY16-AUD and Dante remote mic preampsAgreed. <img src="https://cdn.jsdelivr.net/joypixels/assets/8.0/png/unicode/64/1f642.png" class="smilie smilie--emoji" loading="lazy" width="64" height="64" alt=":)" title="Smile&nbsp; &nbsp; :)"&nbsp; data-smilie="1"data-shortname=":)" />~<img src="https://cdn.jsdelivr.net/joypixels/assets/8.0/png/unicode/64/1f642.png" class="smilie smilie--emoji" loading="lazy" width="64" height="64" alt=":-)" title="Smile&nbsp; &nbsp; :-)"&nbsp; data-smilie="1"data-shortname=":-)" />~:smile:Lately I&#039;ve been using Dante for the FOH stereo feed from the console to a rack of PLM&#039;s, and with analog as the fallback. I notice about 0.5 dB gain difference between the digital and analog but I put this down to tolerances in the analog output of the console.&nbsp; I can make this go away with the digital offset trim in the PLM&#039;s. (The digital is in reference to +4dBu.)On the stability of Dante.... I recently did a stupid thing and pushed a firmware update over wireless to a Lake Contour during a show. (I was bored during one of the talks.) Dante didn&#039;t skip a beat during the update, although I heard one glitch later when the Lake Controller sync&#039;d with the updated unit. The network setup included two DLink gigabit switches (stage and mix ends), PLM&#039;s, Lake Contours, Cisco 10Mb wifi access point (at mix end), MY16-AUD card in the console and a laptop running the Dante Virtual Soundcard.</blockquote>

[QUOTE="Michael John, post: 42997, member: 830"] Re: Yamaha MY16-AUD and Dante remote mic preamps Agreed. :)~:-)~:smile: Lately I've been using Dante for the FOH stereo feed from the console to a rack of PLM's, and with analog as the fallback. I notice about 0.5 dB gain difference between the digital and analog but I put this down to tolerances in the analog output of the console. I can make this go away with the digital offset trim in the PLM's. (The digital is in reference to +4dBu.) On the stability of Dante.... I recently did a stupid thing and pushed a firmware update over wireless to a Lake Contour during a show. (I was bored during one of the talks.) Dante didn't skip a beat during the update, although I heard one glitch later when the Lake Controller sync'd with the updated unit. The network setup included two DLink gigabit switches (stage and mix ends), PLM's, Lake Contours, Cisco 10Mb wifi access point (at mix end), MY16-AUD card in the console and a laptop running the Dante Virtual Soundcard. [/QUOTE]

Verification