Yorkville Excursion

A

Alex Dee

Freshman
Jul 7, 2014
2
0
0
Hi. How are you. This is my first post. I bought the Yorkville Excursion 2000 set up for my buddy to use for gigs. He hasn't used them much so I brought them to my house. I'd like to find a simple interface so I can listen to them at home. It must have two midi outputs to plug in the subwoofer. I only need one input for my ipad (8th inch). What's a good, cheap option that will keep nice sound quality for these speakers? Thanks...
 
Re: Yorkville Excursion

There are no midi connections on the sub.

All you need to connect your iPad to the sub is this:
https://www.parts-express.com/peavey-pv-35mm-trs-male-to-dual-1-4-ts-male-y-cable-10-ft--248-9886

If the cable is not long enough, you can add this:
https://www.parts-express.com/35mm-male-to-female-slim-plug-shielded-extension-cable-25-ft--240-062

If you really want an interface (or rather a small mixer) get what Matt suggested, add the first cable I linked to and add two of these:
https://www.parts-express.com/talent-gc10-guitar---instrument-cable-1-4-male-to-male-10-ft--240-953

You should be set.
 
Re: Yorkville Excursion

as Marcus pointed it out... I could be simpler than a mini mixer (for the iPad). It can't hurt to try it this way; you can also check your local Radio Shack, their cables are pretty reliable.

I pulled this from the manual:
Left & Right Input Jacks: The input jacks of the éXcursion 2000 are designed for operation with line-level signals. The XLR and balanced ¼-inch TRS jacks are wired in parallel, functionally identical except for the style of connector.
Note: The required input level for full power operation, when the Level controls are set to the center detent position, is approximately +4 dBv (1.2 volts). Increasing this setting allows the éXcursion 2000 to be driven with sources that have a low signal level. Connecting signals to both types of inputs on any one channel (XLR and ¼-inch) is not recommended.
 
Re: Yorkville Excursion

Perfect. So to correct my first post those xlr inputs not midi. Am I downgrading by using quarter in y cable instead of xlr?
 
Top Bottom